How to Connect Generator to House Without Transfer Switch?


How to connect a generator to house without transfer switch? It is easy to do and many people already did so to save some money. But there are still some things you need to know. The electricity you use can still be polluted and it will also cause safety problems in your home if you forget to disconnect it. So, how to connect a generator to house without transfer switch?


First, you should check the status of the transfer switch on your generator. Most generators nowadays are equipped with a safety switch which you can open and close whenever you need to. But there are still some generators which don’t have this safety feature and you have to manually switch it off and on.

You have to disconnect the power from your main household wiring system. Take note that the power from the main household wiring system usually has many connections and if you disconnect the power source, the wiring will be overloaded and dangerous for your generator. Start by unplugging the main power from the household wiring system. After this, you have to locate all the wires then you have to take out the connecting cable from the generator. Find the two wires then connect them from the generator to your house’s wiring. This is how to connect a generator to house without transfer switch.

Once you have successfully done the first step, you have to remove the transfer switches on your generator. Then, remove the cables and the other connecting wires from the central unit. Put all the pieces back to their original position to assure that it will work properly once more.

Check the connection of the electrical wires from the service panel. You can use the female plug that is provided on the service panel. Connect the female plug to female wire on the service panel. Now, you can safely attach the male plug to the male wire on the circuit breaker. Since, you have already detached the transfer switches, the circuit breaker can already handle the overload and the power surge.

The next step is to reconnect the generator to its connections. Again, you have to make sure that all the connections are properly secured. If there are any missing connections, you can replace them one by one until all of them are secure. Make sure that when you are connecting a load that has a capacity higher than 50kVA, then you have to use a high efficiency load distribution board.

The fifth step is to set the power controls. There is a common mistake among people that when they connect a load, they automatically turn it on or off. They fail to recognize that there is a transfer switch that is needed for turning on and off the generator. The best thing to do is to leave the power controls off. It will protect you from accidentally turning on the generator when there is still a load connected to it.

The last step is probably the most difficult. It is about testing the generator. To test it, you need to plug it into an electric current and then turn on a load. You should be able to hear a gentle sizzle as the rotor moves back and forth. However, if there are no sounds, then there might be some problems with the interlock kits. If none of the tests succeeds, then you have to call a service technician and ask him how to connect generators to house without using transfer switches.

When you are going to start the generator, make sure that there is an interlock kit installed in the electrical system. You can open the package anytime and make sure that everything is working properly. You can also test the electricity flowing through the wires that are connected to the breaker box by leaving them open for some time.

Once you have done all of these, you can start to test the transfer switch and the central unit separately. You should check the condition of the electrical wiring, particularly the wiring coming from the breaker box to the unit itself. If these wires are in good conditions, then your generator should start easily. However, if there is something wrong with the wiring, then the generator will not start.

Once you are done testing the different components, you should turn the power to the generators and connect it to the electrical wiring. This should give you the expected results. You should not worry if there are some problems because you can always have professionals to help you on how to connect and operate generators. Just make sure that you follow all the steps properly to make sure that your generators are working well.